Still Tugger train Autarkic E Frame, Original Instructions Manual

Page: 102 / 144

5
Operation
Commissioning the C frames
– Release and remove the towing pin from
the tow tractor or a preceding frame. To do
this, depending on the version, press down
the towing pin in the tow coupling on the tow
tractor, turn the towing pin 90° and pull it out,
or release the towing jaw bolt on the frame
and pull it out.
– Insert the trailer tiller into either the coupling
jaw of the tow coupling on the tow tractor or
into the holding fixture of a preceding frame
and secure the tiller in place. To do this,
depending on the version, insert the towing
pin into the coupling jaw, push down against
the pressure of the safety spring, rotate the
towing pin by 90° and lock it in place, or
insert the coupling jaw bolt from the frame
and secure the bolt in place.
– Attach the safety chain to the eyelet on the
tiller.
– Attach the pressure line to the tow tractor
or a preceding frame. Depending on the
design of the tugger train, these lines are
either hydraulic lines or pneumatic lines;
refer to the chapter entitled "Connecting the
plug connector".
– Check whether the C frame is properly
connected to the tow tractor or a preceding
frame.
• The pressure line must lie freely and must
NOT be wrapped around the tiller
• The safety chain must be attached to the
eyelet on the tiller
– Remove the equipment used to prevent the
coupled load from rolling away.
– All other frames must be attached to frames
in front of them and must be connected to
the pressure lines. To do this, proceed as
described above.
96 50988012117 [EN]