Still RX70-16, Original Instructions Manual

Page: 194 / 380

4
Operation
Attachments
Attachments
Fitting attachments
If the truck is equipped with an integrated
attachment (variant) at the factory, the specifi-
cations in the STILL operating instructions for
integrated attachments must be observed.
If attachments are fitted at the place of use,
the specifications in the operating instructions
of the attachment manufacturer must be
observed.
If an attachment is not delivered together
with the forklift truck, the specifications and
operating instructions of the attachment
manufacturer must be observed.
Before initial commissioning, the function
of the attachment and the visibility from the
driver's position with and without a load must
be checked by a competent person. If the
visibility is deemed insufficient, visual aids
such as mirrors, a camera/monitor system etc.
must be used.
In addition, it is essential that the warnings
below are observed.
CAUTION
Attachments must be CE-certified. If the truck is
not fitted with an attachment-specific residual load
capacity rating plate and the operating devices are
not marked with corresponding pictograms, the
truck must not be used.
– Order the residual load capacity rating plate and
pictograms from your authorised service centre
in good time.
– The authorised service centre must adapt the
hydraulic system to the requirements of the
attachment (e.g. by adjusting the pump motor
speed).
182 174749 EN - 03/2017