FR 131 T
English
16
Fitting the Throttle Cable
N
Push the throttle cable (1) into the
two cable retainers (2)
about 20 cm/8 in (A) from either
end of the shaft.
WARNING
The whole length of the throttle cable
must run parallel to the flexible shaft. Do
not wrap the throttle cable around the
flexible shaft.
N
Go to "Adjusting the Throttle Cable".
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N
Set the throttle trigger to the full
throttle position.
N
Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
STIHL brushcutter models with the letter
T in their designations have a split drive
shaft for mounting STIHL KombiTools.
Mounting the KombiTool
N
Push the lug (1) on the drive tube
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
N
Tighten down the star knob (4)
firmly.
Removing the KombiTool
N
Reverse the above sequence to
remove the drive tube.
1
A
A
0000-GXX-1302-A0
2
1
2
Adjusting the Throttle Cable
002BA655 KN
Mounting the KombiTool
1
002BA326 KN
2
3
002BA327 KN
4
Summary of Contents for FR 131 T
Page 1: ...STIHL FR 131 T Instruction Manual ...
Page 2: ......
Page 43: ......
Page 44: ...www stihl com 04584340121A 0458 434 0121 A 0458 434 0121 A englisch G ...