TS 800
English
25
N
Set the choke (4) according to the
engine temperature
N
Press the button (5) of the
decompression valve before each
starting procedure
N
Press the bulb (6) of the manual fuel
pump 7
-
10 times – even when the
bulb is still filled with fuel
Starting
N
Place the cut-off machine carefully
on the ground, ensuring that the
cutting wheel cannot touch the
ground or any objects. There must
not be anyone within the swivel
range of the cut-off machine
N
Make sure you have a firm footing
N
Press the cut-off machine firmly
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
N
Place your right foot into the rear
handle
N
Pull the starter grip slowly with your
right hand until you feel it engage –
then give it a brisk strong pull – do
not pull out the starter rope all the
way
NOTICE
Do not let the starter grip snap back – it
may break! Guide it back into the
housing in the opposite direction so that
it can rewind properly.
When the engine has turned over for the
first time
N
Set choke lever (4) to
o
– press the
button of the decompression valve
again before each starting attempt
and continue cranking
Once the engine is running
N
Squeeze throttle trigger fully and let
engine run at full throttle for
approx. 30 s
N
When it has warmed up, set the
choke lever to
e
N
The master control lever (3) moves
to the normal position
F
when the
throttle trigger is squeezed
c
If engine is cold
e
if the engine is warm (even if the
engine is already running but is still
cold or if the warm engine was shut
off for less than 5 min)
o
if the engine is hot (if the hot engine
was switched off for longer than
5 min)
