TS 800
English
19
Mounting "support with guard" – guard
on the outboard side
N
Fit the "support with guard" (1) on
the outboard side – at the same
time, guide the poly V-belt over the
belt pulley
NOTICE
The belt action must run smoothly.
N
Position the V-belt guard (2)
N
Align studs (3) in bearing with
nuts (4) in the V-belt guard
N
Screw nuts (4) onto studs (3) – do
not tighten them yet
N
Connect water connection
Checking the adjustment range of the
guard
N
Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the ribbed V-belt”.
Inboard mounting
N
Disassemble the abrasive wheel
(see “Fitting / replacing an abrasive
wheel”)
N
Remove water attachment
N
Remove the adjusting lever
N
Slacken the V-belt
N
Remove the V-belt guard
N
Remove "support with guard"
Preparing the "support with guard" for
inboard mounting
N
Unscrew stop pin (1)
N
Turn the guard so that it is in the
position shown (see picture)
N
Screw in and tighten the stop pin (1)
N
Install the adjusting lever
N
Mount "support with guard" – guard
on the inboard side
N
Install the V-belt guard
N
Connect water connection
377BA007 KN
2
1
4
3
377BA008 KN
A
377BA009 KN
1
377BA005 KN
1
