TS 800
English
31
N
The arrow on the tensioning nut (1)
must point to 0 – to this end, turn the
tensioning nut (1) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
N
Unscrew the nuts (2) from the studs
N
Remove the V-belt guard (3) and
remove the poly V-belt from the
front pulley
N
Remove the "support with guard".
N
Remove the hose (4) from the guide
of the starter cover (5)
N
Remove the screws (6) from the
starter cover
N
Remove the starter cover
N
Remove the defective poly V-belt
from the cast arm
N
Carefully fit a new poly V-belt (7) in
the cast arm and insert it in the front
poly V-belt pulley (8) on the engine
N
Fit the starter cover
N
Position the "support with guard"
against the cast arm
N
Fit the poly V-belt in the front poly V-
belt pulley (9)
N
Position belt guard
N
Align the studs in the support with
the nuts in the V-belt guard
N
Screw the nuts onto the studs – do
not tighten them yet
N
Place hose in the guide of the
starter cover
Continue as described in the chapter
“Tensioning the ribbed V
-
belt”.
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
–
repair damaged roadways
–
apply roadway markings
–
cut expansion joints
Replacing the V
-
belt
6
376BA096 KN
6
6
4
1
2
3
5
Cut-off machine cart
1307BA027 KN
