25
Series 4137 Components - HT
:
Disconnect throttle cable nipple
from the throttle trigger.
– Pull the throttle trigger off the
drive tube.
VA
936RA125
:
Remove the torsion spring
(arrow) from the pivot.
Install in the reverse sequence.
VA
936RA126
:
The bent leg of the torsion spring
(1) must engage the slot in the
throttle trigger (arrow).
936RA434
VA
1
:
Fit a square washer on both sides
of the clamps (arrows).
Secure screws only finger-tight at
this stage.
VA
936RA128
:
Make sure the short circuit wires,
throttle cable and tube are
correctly positioned in the inner
handle molding (arrows).
Assemble all other parts in the
reverse sequence.
VA
936RA129
– Remove the throttle trigger,
:
Disconnect the short circuit wires
(arrows).
936RA435
VA
:
Take out the collar screw (1).
:
Remove the detent spring (2).
VA
936RA141
2
1
:
If necessary, pull out the
connector tags (arrows).
936RA436
VA
8.1.2
Detent/Torsion Spring