Stihl 4137 Series, Manual, Page: 29 / 58

28 Series 4137 Components - HT
– Remove the interlock lever,
b
8.2.1
:
Pull the slide control off the
handle molding.
:
Take out the clamp screws.
– Remove the handle molding from
the drive tube.
:
Remove the torsion spring.
Install in the reverse sequence.
– Tighten down the clamp screws
firmly,
b
3.2
:
The slot (1) in the slide control
must engage over the outer edge
(2) of the handle molding.
:
Torsion spring (3) must locate in
the recess (4) in the slide control.
– Remove the shroud,
b
5.1
:
Take out the screw (1).
:
Remove the extended throttle
cable (2).
VA
936RA115
2 1
:
Disconnect throttle cable nipple
(1) from slotted pin (2) on
carburetor’s throttle lever.
VA
936RA116
2
1
:
Pull the throttle cable out of the
tensioner.
VA
936RA117
8.2.2 Slide Control 8.2.3 Throttle Cable