29
Series 4137 Components - HT
:
Pull the short circuit wire
connector off the tag on the
ignition module.
:
Remove the throttle trigger,
VA
936RA118
:
Lift the contact spring (1) slightly
and remove the throttle cable (2).
Install in the reverse sequence.
:
Check that the throttle cable (1),
contact spring (2), protective tube
(3) and insulator (4) are properly
seated.
Install all other parts in the reverse
sequence.
This control handle has a slide (1)
for automatic adjustment of the
throttle cable.
:
Insert a screwdriver in the slot,
press the slide down and push it
in the direction of the engine.
936RA437
1
VA
:
Take out the screws (arrows).
and remove the handle molding.
:
Remove the torsion spring.
:
Pull the throttle trigger (1) with
attached throttle cable (2) off the
pivot.
VA
936RA251
1
2
:
Disconnect the throttle cable
from the throttle trigger.
VA
936RA249
8.3
Control Handle from 2002
8.3.1
Throttle Trigger/Interlock
Lever