![background image](http://html1.mh-extra.com/html/stiebel-eltron/ste/ste_commissioning-manual_1376889041.webp)
COmmISSIONING
Controller menu
www.stiebel-eltron.com
STE |
41
EN
GL
ISH
Alarm delay
f
f
Set a time after which an error message is displayed on the
appliance.
Heating circuit 2 / 3 / 4 / 5
Note
The extension module is required for heating circuits 2-5.
Each extension module supports two heating circuits.
Activate heating circuit x
Can only be activated when a module is selected.
f
f
Activate or deactivate the function.
When the function is activated, the settings made here apply for
the corresponding heating circuit. The corresponding symbol ap-
pears in the main menu. The symbol allows you quick access to
this menu.
When the function is deactivated, the higher ranking settings are
used to control the heating circuit.
Selected module
f
f
Set the module to which the necessary components are con-
nected.
Min. flow
f
f
Set the minimum temperature for the system flow.
Max. flow
f
f
Set the maximum temperature for the system flow.
Activate room sensor
f
f
Activate or deactivate the function.
When the function is activated, the sensor measures the current
room temperature.
Passive = 0, active = 1
f
f
Set whether the temperature is measured actively or passive-
ly.
If the temperature is measured actively, the room sensor influ-
ences the heating mode.
Set temperature
f
f
Set the temperature to which the assigned rooms should be
heated.
Influence of room temperature sensor
f
f
Set whether the room sensor only measures the temperature
or also helps to control the room temperature. The higher the
value, the more influence the room sensor has.
Cooling
Passive cooling
Active cooling
Selected module
Surplus heat: Brine = 1, cooler = 2
Summer mode cooling temperature
Hot gas start temp. Cooling
Shutdown temp. Cooling
Minimum compressor stage
Maximum compressor stage
Switching delay
Delay, directional valve, source
Cooling – mixing valve
Set cooling temperature
Activate dew point sensor
Alarm limit deviation
Alarm delay
Cooling – cylinder
Alarm high limit
Alarm delay
Cooling – surplus heat
Set return temperature
Alarm limit deviation
Alarm delay
To be able to cool with the primary and secondary heat pumps, the
heat pumps must be connected to the same heat source.
Passive cooling
For passive cooling, the brine is routed through the bore hole
where it is cooled.
f
f
Set passive cooling on the primary heat pump.
f
f
Set passive cooling on the required secondary heat pumps.
Active cooling
For active cooling, the brine is routed through the condenser and
actively cooled via the refrigerant circuit. The waste heat can be
used for the heating mode, DHW heating or swimming pool heat-
ing. When the waste heat is not needed, it is routed through the
bore hole or to the air cooler.
f
f
Set active cooling on the primary heat pump. The secondary
heat pumps are activated automatically.
Parameter
Unit
Buffer cylinder temperature
°C
Current temperature in the cooling buffer cylinder
Flow temperature, cooling
°C
Passive cooling
Can only be activated when a module is selected.
f
f
Activate or deactivate the function.
When the function is activated, the building is cooled passively.
The corresponding symbol appears in the main menu. The symbol
allows you quick access to this menu.