Safety
Operating instructions (Version 0)
17
ST 1075
2
• Do not operate equipment with a damaged cord or
if the equipment has been dropped or damaged
until it has been examined by a qualified
serviceman.
• In case of using one or two lifting columns (in
paired operation), be sure that this will not result
in stability risks. In case of doubt, consult your
superior. Unsafe lifting can result in serious injury
and damage to the lifting system and/or vehicles.
• This mobile lift should only be used for lifting of
vehicles and not for other applications. The
positioning of the lifting system must be done in a
way that a safe working area will be obtained,
thereby creating escape paths for emergency
situations (leave passageways of at least 24").
• For important vehicle technology see section
4.3 ’Safety when hoisting’ on page 29
.
• If a vehicle is in the lifted position, its air
suspension system may not be used in a view of
possible change of track width and/or wheel base.
• Use the lifting columns only on a hard and level
floor with sufficient bearing capacity, see the
specifications for floor pressure and floor load in
Table 3.1 ’Specifications’ on page 22
.
• Whenever a vehicle is raised on the lift, always
raise the mobile column lifts to at least above the
first safety lock.
Summary of Contents for ST1075-FBF
Page 21: ...Safety Operating instructions Version 0 21 ST 1075 2 Figure 2 2 Safety and warning labels ...
Page 78: ...Operating instructions Version 0 78 ST 1075 A 2 Hydraulic unit Figure A 2 Hydraulic unit ...
Page 90: ...Operating instructions Version 0 90 ST 1075 A 9 Label locations Figure A 9 Label locations ...
