Service and troubleshooting
Operating instructions (Version 0)
51
ST 1075
7
7.3
Programmable settings
Pressing <SELECT> and <SLOW LOWERING> (turtle) continuously for 2 seconds
activates the service menu.
The screen looks like this:
The functions can be selected using the <UP> and <DOWN> buttons:
The <SELECT> button enables or disables a function.
The <SLOW LOWERING> (turtle) button confirms the choice and exits the service
menu.
7.3.1 Height limit
If this function is <OFF>, the mobile lift stops in the highest position at the fixed value
set in the software. The height limit can be programmed as follows:
1.
Position the column at the required height.
2.
Lower the column lift into the pawls and then raise it approx. 1 inch, to be sure that
the highest position is well above the locking position.
3.
Switch the function <ON> and exit the service menu.
Note
n
The setting is switched <ON> by all the columns in the set. Each column sets the
current height is set as the limiting height, even if the current height has been raised
or lowered with the <SINGLE> or <PAIR> functions. This therefore means that the
other columns can have a height limit that differs from the height limit for the column
that it was set from.
Figure 7.1
Service menu
Height limit
Height dimension
Weight category
Unlock during up
Language
Motor type
Crush limit
Motor run hrs
Footguard
Height diff.guard
System run days
Height guard
ZB:Long distance
Odd nr of columns
Weight dimension
SERVICE MENU
Height limit
OFF
Unlock during up
OFF
Crush limit
ON
Height diff.guard
ON
Height guard
ON
Odd nr of columns
OFF
Summary of Contents for ST1075-FBF
Page 21: ...Safety Operating instructions Version 0 21 ST 1075 2 Figure 2 2 Safety and warning labels ...
Page 78: ...Operating instructions Version 0 78 ST 1075 A 2 Hydraulic unit Figure A 2 Hydraulic unit ...
Page 90: ...Operating instructions Version 0 90 ST 1075 A 9 Label locations Figure A 9 Label locations ...
