stertil-KONI ST1075-FBF, Installation, Operation And Maintanance Instructions

Page: 45 / 102

Inspection and maintenance
Operating instructions (Version 0) 45 ST 1075
6
For additional details, see chapter 7 "Service and troubleshooting" on page 50 .
6.3 Maintenance procedures
6.3.1 Lubrication program
The column lifts must be serviced regularly in accordance with the lubrication
program.
6.3.2 Hydraulic oil
Replace the hydraulic oil in the tank approximately once every 2 years.
Note
n
This oil change must take place as scheduled, even when the column lifts are not in
continuous use.
When changing the hydraulic oil, proceed as follows:
1. Fully lower the column lifts and drain off the oil.
Table 6.1 Lubrication program
Maintenance tasks Description Monthly
Annual
(technical
service)
Every 2
years
(technical
service)
Cylinder Lubricate piston rod if
dry (machine oil) x
Check oil level in tank Top up (only with
column lifts fully
lowered) x
Various pivot points Lubricate x
Hydraulic oil in the tank Replace (2.6 gallon) x
Suction filter Clean or replace x
Safety lock Check and clean if
required x
Safety lock Disassemble, clean
and (if necessary)
replace and adjust
(see §
6.3.5 )
x