stertil-KONI ST1075-FBF, Installation, Operation And Maintanance Instructions

Page: 26 / 102

4
Operating instructions (Version 0) 26 ST 1075
4 Installation
4.1 Unpacking and setup
Proceed as described below when unpacking and setting up each column.
Warning
w
Only use proper lifting equipment to move the column lift. Lift the column only at the
points intended for this. Failure to relocate the column lift in the right manner can
cause damage to the column lift and/or personal injury.
1. Transport the column lift to the location where it will be used.
2. Remove the lid of the crate, or the straps on the transport pallet.
3. Attach a hoisting belt rated at a minimum of 1100 lbs around the column lift, and raise
it out for the crate (see
Figure 4.1 ).
Warning
w
Do not enter the area below the column lift while it is suspended from the lifting
equipment. If it should fall, it could cause serious injury.
4. Lower the column carefully to the floor.
5. Attach a hoisting belt to the top of the column.
6. Raise the column until it is upright.
7. Remove the hoisting belt.
8. The control cabinet assembly can now be put together (if delivered separately).
Figure 4.1 Lifting the column
Crate or pallet
Hoisting belt