Installation
Operating instructions (Version 0)
29
ST 1075
4
18.
Also attach the negative cable (3) from the battery charger to the negative terminal
of the bottom battery.
19.
Connect the positive of the black connector cable (13) to the positive of the battery.
20.
Place the top battery with the negative terminal on the same side as the battery
charger.
21.
Connect the red positive cable (12) to the positive terminal of the top battery.
22.
Also connect the red positive cable from the battery charger (3) to the positive
terminal of the top battery.
23.
Connect the negative of the black connector cable (13) to the negative of the top
battery.
24.
Connect the RF-module.
25.
Connect the safety swich according to the electrical drawing.
26.
Remove the stopper from the filler opening and attach the air bleed cap.
27.
Close the door and fix it in place with the two M6 bolts.
28.
Check for oil leaks.
4.2
Linking the column lifts
Sets comprising 2 to 8 columns can be put together using interconnection cables.
The linked columns are referred to as a
set
.
Several sets can be used next to one another in the same area. A maximum of 60
columns can be used.
The columns are absolutely identical. The columns work independently of the mains
supply. The mains supply is only required for loading the batteries.
The lifting capacity for the ST 1075 model is 16,500 lbs per column; a set of 4 can
therefore lift 66,000 lbs (max.).
Note
n
By default, the operating system will only accept an
even number of columns
.
This helps avoid situations where a column is not properly registered or missed out
accidentally while columns are being linked. After the link procedure, the number of
columns found is reported and this is continually visible on the screen. In specific
cases, the service team can disable this additional check.
4.3
Safety when hoisting
In principle, the individual and per-axle control over the column lifts is intended to
enable the vehicle to be raised horizontally, or alternatively to be lowered onto axle
supports.
Summary of Contents for ST1075-FBF
Page 21: ...Safety Operating instructions Version 0 21 ST 1075 2 Figure 2 2 Safety and warning labels ...
Page 78: ...Operating instructions Version 0 78 ST 1075 A 2 Hydraulic unit Figure A 2 Hydraulic unit ...
Page 90: ...Operating instructions Version 0 90 ST 1075 A 9 Label locations Figure A 9 Label locations ...
