Steris Basil 1100, Operator'S Manual

Page: 27 / 48

4-5
Operating Instructions Operator Manual 122996-004
1. If display shows STANDBY , press FILL/PURGE . Assure bottle fill area is
empty.
2. Press FILL/PURGE . System will purge for the purge time set (default is 25
seconds).
3. When display shows READY , position a rack full of bottles in the fill area.
4. Press FILL/PURGE . Display counts down the time programmed (default
time is 5 seconds for A TIME and 10 seconds for B TIME ).
NOTE: When filling the bottles, note the following:
1) Fill times may vary somewhat, depending on the size of the bottles.
2) If time is set to zero and an attempt is made to purge or fill, display will show
NO TIME, then time must be set (refer to Section 4.1.6, How to Change Filling
Time Settings).
3) Operation of the unit may be stopped at any time by pressing STOP. Display
will go blank. Twist STOP button to release it and return proportioner to Standby
mode.
After a rack of bottles is filled, an internal timer begins counting down for five
minutes. If another fill cycle is run, the timer resets to five minutes and begins
counting down again. If the timer counts down five minutes without beginning
another fill cycle, then proportioner will switch into Standby mode. Display will
show:
STANDBY , and pump will shut off.
NOTE: Pump runs continuously while proportioner is in ready mode.
Clean unit as described in Section 5, Routine Maintenance.
4.2.2 Acid Proportioner
Units
4.3 Standby Mode
(Acid Proportioner
Units)
WARNING – CHEMICAL
BURN AND/OR EYE INJURY
HAZARD: When filling
bottles, always wear gloves
that are appropriately re-
sistant to the chemicals
being used.