Steris Basil 1100, Operator'S Manual

Page: 25 / 48

4-3
Operating Instructions Operator Manual 122996-004
NOTE: Purge is used for two different purposes:
1) To purge piping and manifold of all the previously selected water type
before filling the next rack of bottles with the new type of water selected.
2) To assure uniform bottle filling after unit has been sitting idle for more than
five minutes since the previous fill cycle.
1. Display shows:
READY
or
STANDBY
2. Press FUNCTION/SELECT until display shows:
PURGE TIME
3. Press SET/SAVE . Current purge time is displayed. Tenths of seconds are
flashing.
4. Press FUNCTION/SELECT until the desired tenths of seconds is displayed.
5. Press SET/SAVE . Seconds are flashing.
6. Press FUNCTION/SELECT until desired seconds is displayed.
7. Press SET/SAVE . Minutes are flashing.
8. Press FUNCTION/SELECT until desired minutes value is displayed.
9. Press SET/SAVE . The controller will emit three rapid beeps and display will
go to READY or STANDBY .
Two different preset filling times can be adjusted so that two different size
bottles can be filled during separate cycles. The two filling times are identified
as "A Time" and "B Time". To select the filling time, proceed as follows:
1. When displays shows READY or STANDBY , press FUNCTION twice.
Display shows:
FILL TIME
2. Press SET/SAVE . Display shows:
A TIME
or ...
B TIME
3. Press FUNCTION to select desired time.
4. Press SET/SAVE to confirm the selection. There will be three rapid beeps
and display goes back to READY or STANDBY .
4.1.4 How to Set Purge
Time
4.1.5 How to Select Filling
Time