Steris Basil 1100, Operator'S Manual

Page: 24 / 48

4-2
122996-004 Operator Manual Operating Instructions
3. To prime injection pump, fill solution tank with approximately one gallon of
water, or enough to cause the display to stop flashing CHEMICAL TANK
LOW .
4. Press SET/SAVE . Display shows:
PRIME?
5. Press SET/SAVE again. Display shows:
PRIMING
...and the injection pump will begin to pump.
6. Loosen the tube fitting at the injection valve and remove tube from fitting.
7. Insert tube into a container. This will make it easier for the pump to complete
priming.
NOTE: Since solution tank is near floor level, placing tank at the same level as
the pump or higher will speed priming greatly.
8. The injection pump is primed when all the air bubbles are out of the solution
tubing and water is coming out of tube, into the container.
9. Press FUNCTION/SET . The injection pump will stop and display will show
STANDBY .
10. Reconnect the tube at the injection valve. Proportioner is now ready.
Display can show either READY or STANDBY .
1. Press FUNCTION/SELECT . Display shows:
WATER
2. Press SET/SAVE . Display will show:
TREATED
or
PLAIN
3. Press FUNCTION/SELECT to select other water type.
4. Press SET/SAVE . There will be three rapid beeps, and display shows:
STANDBY
5. The unit will now dispense type of water selected.
NOTE: Anytime the proportioner is changed from plain to treated water or vice
versa, the proportioner will go into Standby mode. A Purge cycle must be
performed before filling a rack of bottles. The Purge cycle purges the mixing
chamber, piping, and manifold of the previously chosen type of water.
4.1.3 How to Change
Water Type
WARNING – CHEMICAL
BURN AND/OR EYE INJURY
HAZARD: When filling
bottles, always wear gloves
that are appropriately re-
sistant to the chemicals
being used.