Steris Basil 1100, Operator'S Manual

Page: 14 / 48

2-4
122996-004 Operator Manual Uncrating/Installation Instructions
Once unit is level, install anchorage system as follows:
1. Mark floor holes position. (If anchoring brackets do not touch the floor, use
shims.)
2. Using a forklift, move the unit to clear area.
3. Drill holes in floor.
4. Using a forklift, bring unit back into position.
5. Bolt brackets into position using bolts provided.
1. DRAIN - Connect building waste line to unit drain line.
2. COLD WATER - Connect cold water supply line from building to unit as
described in the Equipment Drawing.
3. ELECTRICITY - Connect building electrical supply line to unit electrical
supply box as described in the Equipment Drawing.
1. Remove any adhesive found on panels with a small amount of nonflam-
mable cleaning solvent. Keep solvents away from all painted surfaces or
damage may result.
2 Remove all protective paper from the unit cabinet panels. Slowly peel paper
away from stainless steel to reduce the level of static discharge.
3. Inspect filler head and filling area to assure all materials used during
installation have been removed.
THIS COMPLETES THE INSTALLATION. Before operating equipment,
confirm that all items on installation checklist have been satisfactorily imple-
mented and operational test is conducted by a qualified service technician.
Follow procedure described in Section 4.2,
Bottle Filler Operation, to test unit
operation.
2.2.4 Connect Utilities
2.2.5 Cleanup
WARNING – HEALTH HAZ-
ARD: Vapors from solvent
can be harmful. Use with
adequate ventilation. Fol-
low directions on the con-
tainer.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
When removing adhesives
from stainless steel, use a
solvent specially formu-
lated for that purpose. Rub
in a back-and-forth motion
(in same direction as sur-
face grain). Solvent rubbed
in a circular motion or ap-
plied with a wire brush or
steel wool on assemblies
can be harmful to stainless
steel. Do not use solvents
on painted surfaces.
2.2.3 Install Anchorage
System