Rail Runner LT
Rail Runner LT
– Operator’s Manual
11
3.2. Assembling the ring track
Select the track that matches the outer diameter of the round workpiece. Use the
4 mm hex wrench to attach the supports to the rails (
1
, Fig. 3). Next, on all supports,
retract the bolts (
2
, or screws) as much as possible.
Fig. 3.
Connecting the supports to the rails
Put the workpiece vertically, and then put the rails onto the workpiece so that the
teeth of the racks point down. Next, for all rails, use the 12 mm hex wrench to set
the hinge as shown in Fig. 4. Then, put the lock pin through the holes (
1
), and then
rotate the wrench (
2
) to connect the rails.
1
2
2
Screw with plastic foot
25 mm (1
″) adjustment range
Bolt
25 mm (1
″) adjustment range
Screw with magnet
25 mm (1
″) adjustment range
