Rail Runner LT
Rail Runner LT
– Operator’s Manual
9
3. STARTUP AND OPERATION
3.1. Assembling the semi-flexible or rigid track
Connect magnetic units to the rail, and put it on the workpiece. Use the 4 mm hex
wrench to attach more rails (
1
, Fig. 1). Then, set
the levers of the magnetic units to ‘I’
(
2
). This will clamp the track to the surface.
When working in PC/2G welding position, put the track so that the teeth of the
racks point down.
Fig. 1.
Connecting the rails and clamping the magnetic units to the surface
If a semi-flexible rail is put on a curve, before you attach more rails use the 4 mm hex
wrench to loosen the screws of the connecting plates (
1
, Fig. 2) and of the racks (
2
).
Next, attach the rails, clamp them with levers, and then tighten the connecting plates.
Put the rack adjustment tool (not included) into the hole (
3
), and rotate the tool to the
left (
4
) to remove the gap (
5
) between the racks. Then, tighten the leftmost screw and
the rightmost screw of each rack (
2
).
1
2
