Rail Runner LT
Rail Runner LT
– Operator’s Manual
21
3.9. Troubleshooting
Message
Cause
Solution
Display not lit fully when powering.
Contact service center for check and
repair.
Speed shown in centimeters per
minute instead of inches per minute.
Contact service center.
Speed shown in inches per minute
instead of centimeters per minute.
Contact service center.
1. Travel direction switch not set to ‘O’
when powering.
2. Shown during travel indicates
a malfunction of the switch or
controller.
1. Set the travel direction switch to
‘O’. If the message still shows, contact
service center for check and repair.
2. Contact service center for check
and repair.
Arc ignition switch not set to ‘O’ when
powering.
Set the arc ignition
switch to ‘O’. If the
message still shows, contact service
center for check and repair.
Motor overload that promptly stops
the carriage.
Adjust the position of the cables so
that they do not block the travel.
Remove other elements that block the
carriage or the drive gear.
If this message still shows, contact
service center for check and repair.
