Star-Light DPJ-800W, Instruction Manual

Page: 2 / 28

2
Do not disassemble the juice extractor when it is plugged to the power supply. Always unplug the
appliance from the power supply before cleaning and when not in use.
To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids.
If it happens, unplug it immediately and check in a service center.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not leave the appliance switched on when not in use.
Do not use other attachments than those supplied.
Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the
malfunctioning appliance in the nearest service center only.
Keep the cord away from sharp edges and hot surfaces.
Do not pull, twist or wrap the power cord around the appliance.
Do not place the appliance near gas or electric oven or store at heated surface.
The grating filter is very sharp, so handle it with care.
Always make sure the safety lock is fastened correctly before switching on. The unit is designed
to shut off automatically if locks are not fastened securely in place.
Do not push products into the appliance by fingers while it is in use. If food becomes lodged in
feeder tube, use pusher to push it down. If this doesn’t work, turn the motor off, unplug unit, and then
disassemble juice extractor to remove remaining food.
Do not run juice extractor continuously for longer than 10 minute.
Turn off the switch and let the appliance to rest for at least 10 minute to cool down the motor,
otherwise the motor may be damaged.
Every time make sure that the appliance is unplugged and all moving parts with motor are stopped
completely before disassembling and cleaning.
Be sure to switch off the unit after each use.
Do not overload appliance with products.
If the product has been exposed to temperatures below 0ºC for some time it should be kept at room
temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes into the product design without
prior notice, unless such changes influence significantly the product safety, performance, and functions.
2. BEFORE USING FOR THE FIRST TIME
After unpacking the unit and before any use, make sure the mechanical parts of the unit and all
attachments are not damaged.
Wash and dry all parts of the appliance, which will come into contact with the products. To clean
the outside of the body use a damp sponge.
Practice assembling and dismantling the unit a few times before making juice.
3. HOW TO ASSEMBLE
DISMANTLING:
Unplug the appliance from the power supply.
Open the locks.
Remove the transparent lid, pull the grating filter upwards, then take off separating unit.
ASSEMBLING:
Place the separating unit on the motor unit, push with both hands on the separating unit until it
clicks into place.
Insert the grating filter; turn it clockwise to fit securely.
Mount the transparent lid and fasten the locks.
Place the pulp container under the cover, and the glass
– under the beak for juice.
Plug the appliance to the power supply.
4. OPERATING INSTRUCTIONS
Before starting make sure that the juicer is switched off and transparent lid fixed properly.
Wash fruits and vegetables thoroughly. Cut fruits into small pieces so as to be fitted into the feeding
tube. Remove the stone or peel from those citrus and fruit: prunes, apricots, cherries or oranges, lemons,
melons, etc.
Connect the juice extractor to mains.
Before initial operation switch the juice extractor on with no food inside and operate for five
seconds.
Default settings will appear on the display, e.g.: Speed setting - "3", Program setting -
"PINEAPPLE".
You can select one of five programs, depending on the type of food being processed. Press "+" or
"-" button to select.