Stanley QPM CORDLESS TOOL, Instruction Manual

Page: 50 / 56

Cordless Tool
44
Battery and Charger
4 Maintenance
WARNING
POTENTIAL FOR UNSAFE CONDITIONS
To Avoid Injury
• To reduce the risk of serious personal injury, disconnect battery pack before performing maintenance, making
any adjustments or removing/installing attachments or accessories.
• Failure to perform proper maintenance could result in unsafe and hazardous conditions.
• Failure to perform proper maintenance could significantly reduce gear life.
These nutrunners are designed to give the industrial user long service and superior performance provided they are
given reasonable care and maintenance and are used under normal operating conditions.
4.1 Battery and Charger
The charger and battery pack are not serviceable. There are no serviceable parts inside the charger or battery
pack.
READ ALL OF THE INSTRUCTIONS IN THE BATTERY CHARGER SECTION OF THIS MANUAL BEFORE ATTEMPTING
TO CHARGE THE BATTERY PACK FOR YOUR TOOL.
If you have any questions, call +1 (440) 461-5500.
4.1.1 Charger Cleaning Instructions
Disconnect the charger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
4.2 QPM Cordless Tool
4.2.1 Preventive Maintenance
All power tools will experience wear of internal parts throughout their normal working life. A good preventive
maintenance program will allow worn components to be replaced before actual failure occurs.
Because of the wide variety of assembly applications and user techniques in industrial applications, it is impossible
to predict the life expectancy of any particular component.
We recommend following the STANLEY Assembly Technologies
Preventive Maintenance Guidelines
document schedule for inspecting the internal components. This power tool’s maintainer should keep records and
adjust the maintenance schedule for each particular assembly operation. Contact your local STANLEY Assembly
Technologies representative for a copy of the
Preventive Maintenance Guidelines . We recommend:
• Schedule all power tools for periodic inspection and maintenance.
• Replace noticeably worn parts before wear occurs on adjoining parts.
• Replace bearings when any axial or radial play becomes apparent.
• Use only genuine STANLEY replacement parts
4.2.2 Calibration
The QPM cordless tool’s torque transducer must be calibrated annually or after repair to maintain its accuracy.
4.2.3 Repairs
Consult the repair parts lists for part identification and assembly instructions. Order all replacement parts by part
number from your local STANLEY Assembly Technologies representative.