Stanley QPM CORDLESS TOOL, Instruction Manual

Page: 42 / 56

Cordless Tool
36
Start Trigger Switch
Function Description
Disable The Multi-Function button does nothing.
Reverse (Disassembly)
Pressing the button toggles between assembly and disassembly modes
and illuminates the appropriate blue light [
1 ] or [ 2 ]. All tool status lights
[ 3 ] and [ 6 ] flash when the tool is in disassembly mode.
Job/Task Select
Pressing the button toggles between Job/Task 1 and Job/Task 2 and
illuminates the appropriate orange indicator light [
4 ].
Arm
Pressing the button arms (activates) the trigger but does not start the tool.
The blue assembly light [
2 ] illuminates to show that the tool is armed for
five seconds.
Reset Reject
This function, when selected, will cause the tool to disable after a NOK
fastening cycle. The Reject Tone, when enabled, will sound. Pressing the
button re-enables the tool indicating the operator acknowledges the
rejected fastening cycle and wishes to repair it.
Job Reset
Pressing the button causes the selected Job to be reset. This means that
the fastener count is reset and the tool, if disabled due to Error Proofing
requirements, re-enables.
Reset and Reverse
This function, when selected, causes the tool to disable after a NOK
fastening cycle. The Reject Tone, when enabled, will sound. Pressing
the button re-enables the tool in Reverse mode and indicates that the
operator acknowledges the rejected fastening cycle and wishes to repair
it. The tool switches to the forward direction after the controller detects a
fastener has been removed.
3.3 Start Trigger Switch
The trigger switch is used to start the tool in either direction. The speed of the tool is programmed and the
internal digital circuit controls the speed of the tool, not the trigger switch. It is not a variable speed trigger. The
trigger switch function is on or off. Press the trigger switch to start the tool. Release the trigger switch to allow
the tool to stop.
3.4 Tool Memory
QPM tools have an on board tool memory that stores tool identification, calibration factors and fastening cycle
counters. Memory parameters include:
• Model Number
• Serial Number
• Torque Cal (calibration) factor
• Gear Ratio
• Fastening cycle counters
• Jobs parameters
• Fastening cycle data
• Trace data
3.4.1 Fastening Cycle Counters
QPM tools have on board counters that record the number of fastening cycles completed by the tool. There is
a limited number of times the controller can write to this memory. The cycle counts are updated on the tool