Standard Horizon CP190i, Owner'S Manual

Page: 16 / 160

CP190i and CPF190i Page 17
2. INSTALLATION
NOTE
Throughout this Owner’s Manual same conventions are used. See the legend below:
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
GENERAL SETUP When a word(s) is bold capital letters and underlined, this refers to a menu
selection item.
A GPS Receiver and antenna are located inside the CP190i and CPF190i and are designed
to be bracket mounted. Both models may be flush mounted, however an optional external
GPS antenna may be needed to receive GPS satellite signals.
To use the external GPS antenna, the internal GPS antenna must be turned off, using the
procedure below:
1. Turn the CP190i and CPF190i On and select the
GPS STATUS page.
2. Press [ENT] to show the GPS SETUP menu.
3. Move the ShuttlePoint knob to highlight INTERNAL GPS and press [ENT] .
4. Move the ShuttlePoint knob to highlight OFF and press [ENT] .
INTERNAL GPS
RESTART GPS
NAVIGATION SPEED
NAVIGATION FILTER High
DIFF CORRECTION SOURCE WAAS/EGNOS
Off
On
Figure 2 - GPS Setup menu
5. Press [CLR] to exit the GPS SETUP menu.
6. Confirm the GPS Status page is showing satellite signal strength bars and receive a fix.
2.0 MOUNTING THE GPS CHART PLOTTER
The CP190i and CPF190i are supplied with a swivel mounting bracket which allows them
to be dash mounted. When flush mounting, the optional GPS antenna may be needed to
receive GPS satellite signals. Refer to the images below for Bracket and Flush mounting.
NOTE
The CP190i and CPF190i are designed to be bracket and flush mounted. However when bracket
mounting the CP190i and CPF190i in an area where satellite reception is not possible with the
internal antenna or when flush mounted, the optional GPS antenna must be installed.
2.1 BRACKET MOUNTING
Before installing ensure the area the bracket is mounted to is strong enough to support the
weight of the GPS Chart Plotter especially while under way. After the location is found,
attach the mounting base to the area using the supplied hardware.