Stairmaster FREECLIMBER 4200 PT, Owner'S Manual

Page: 23 / 99

Page 14
HEART RATE MONITORING
2. There are four options to handle heart rate input signals.
Press the [SELECT] key to scroll through the options until you
find the one option that suits your needs. Press the [ENTER]
key to select that option.
“ BOTH HR ON “ - allows either telemetry or contact heart rate
signals to be detected. Once the console has detected a valid
input signal it will lock out the opposite type of signal for the
duration of the workout session. For example, if you start out
using contact heart rate then you are limited to using only contact
heart rate during your workout session, even if the signal is lost
while performing the workout, and vice-versa.
“ BOTH NOT LOCKED” - allows either telemetry or contact
heart rate signals to be detected. Does not lock out a particular
input signal for the entire workout. This option will detect either
input signal during a workout session, but only one at a time, and
only until the other signal terminates.
“ TELEMETRY ONLY “ - locks out contact heart rate signals
and will only detect telemetry signals.
“ HAND ONLY “ - locks out telemetry signals and will only detect
contact heart rate signals.
“ BOTH HR OFF “ - turns off the ability to detect any signal at all.
Used in rare situations where there is excessive interference with
the heart rate signals. *This option disables the Constant HR
program and the Fitness Test program.
Error Messages
Text line messages are only seen in the Constant Heart Rate and Fitness Test
programs due to the design of the program that necessitates a valid heart rate
signal during the program. For these programs, ensure that neither the “BOTH
HR OFF” or the “HAND ONLY” option is set as a default option.
“ CHECK HR BELT ” - The heart rate signal has been missing for the last 30
seconds in telemetry signal detection.
“HR BELT NEEDED” - No telemetry belt signal has been sensed during the
initial setup time.