Stairmaster Crossrobics 1650 LE, Owner'S Manual

Page: 74 / 108

Page 65
PARTS REMOVAL AND REPLACEMENT
5. To reassemble the pivot pulley shaft and bearings, reverse these
procedures.
6. Adjust the HTD and the alternator Poly-V belts (see the “Alternator
Poly-V Belt” and “HTD Belt” sections for tensioning instructions).
Adjust the HTD belt first, then the alternatorPoly-V belt.
7. Reattach the right rear and left side covers.
SELECTOR ROD
1. Remove the outside weight stack cover.
2. Remove the weight selector pin, lift the first three plates to create
slack in the weight stack belt and remove the belt from the top two
idler pulleys. Set the plates back down onto the stack.
3. Punch out the roll pin in the third weight plate and remove the
selector rod from the weight stack (see Figure 19).
4. Punch out the roll pin securing the weight stack belt connector plates
to the selector rod.
5. Install the new selector rod by reversing the steps.
SHOCK MOUNT
1. Remove the side cover(s).
2. Have an assistant depress and hold the pedal arm down.
3. Loosen the locking set screw and unscrew the shock mount (see
Figure 9).
4. Screw in the new shock mount. Tighten the set screw so that it just
comes into contact with the shock mount screw.
5. Release the pedal arm.