Stairmaster Crossrobics 1650 LE, Owner'S Manual

Page: 42 / 108

Page 33
MAINTENANCE INSTRUCTIONS
HELPFUL HINTS
Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks. All references
to the right or left side and to the front or back are made as if you were on the
machine ready to exercise. Major component names and locations are shown
in Figure 7.
TOOL LIST
The following tools are needed to perform service and maintenance:
• Torx screwdriver • phillips screwdriver
• combination wrenches (sizes 7/16 - 3/4")• wonder bar (included w/ unit)
• combination pliers
• locking pliers
• volt-ohm meter (multimeter) • wire stripper/crimper tool
• allen wrench set (sizes 5/64 - 1/4") • external snap ring pliers
• shop goggles or other eye protection • torque wrench
• socket set or nut driver set (sizes 1/4 - 3/4" in 1/16" increments)
MAINTENANCE RECORDS
For ease of maintenance the Crossrobic ® console will keep track of hours,
number of workouts, time between last servicing, etc. You can quickly access
any of the custom menus by pressing
[LEVEL: ^], [4], [ENTER]. The console will
then display “MACHINE STATUS.” Scroll through the following options:
[ SELECT ] “ RUN HOURS XXXX”* 0
[ SELECT ] “ WORKOUTS XXXX” 1
[ SELECT ] “ DISTANCE XXXX” 2
[ SELECT ] “ CONS 90211- XXX ” 3
[ SELECT ] “ CROSSROBIC ” 4
[ SELECT ] -N/A-
[ SELECT ] “ MAINT HOURS xxxx” 6
*The machine may show a few hours of use due to testing at the
manufacturing facility.