St George Mobile GPRS EFTPOS, Operating Manual

Page: 7 / 96

HyPERCOM MOBILE GPRS MERCHAnT OPERATInG GUIDE – GETTInG STARTED
5
2.3 Terminal Display.
Signal Strength – number of bars indicates strength of the GPRS signal.
When no signal is detected just the Y will appear. Three bars indicate good
signal strength.
Battery - Internal battery power level displayed when terminal is not connected to
mains power.
Battery Charging - This symbol will display alternately with the battery strength
indicator when the terminal is plugged into mains power and charging.
2.4 Power Supply.
The terminal can operate on mains power as well as on battery power.
The terminal operates on a fast charge set up. It takes approximately three hours to fully
charge the battery. When fully charged, the terminal will give up to ten hours of usage or
can process approximately 200 transactions before needing a recharge.
The terminal is recharged by plugging the terminal into mains power using the charger
supplied, or the optional docking cradle.
XX XXXX XXXX XXXXX
XXXXXXXX XXXXX XXXXXXX XXX XXXXXX
XX XXXXXXX XXXXXX XXX XXXXX XX
XXX XXXX XX XXXX XXXXXXXXX
POWER SERIAL
Power
XXXXXX
XXXXXXX
XXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXX
Docking Cradle (optional) normal Charger
Powering the Terminal On and Off
When the terminal is not connected to the mains power and is left idle for 10 minutes, the
terminal will go into ‘sleep mode’ to preserve battery. The terminal display will go blank,
however the terminal will still be connected to the network. To start using the terminal
again, press any key. After 60 minutes of inactivity the terminal will automatically shut
itself down. If you wish to alter these timeouts, please contact the Helpdesk.
To turn the terminal back on, press the FUnCTIOn key for approximately five seconds
until you hear a beep.
To switch the terminal off manually, press the FUnCTIOn key from the idle screen for
approximately five seconds until the display goes blank.