User Manual
Embedded EtherNet/IP Module
GS11-EI
18
The fourth bit of DIP is “Default IP address locking” bit. When this bit is “ON”, Module is in firmware
update state (unable to communicate normally), and the module will start up with default IP configuration.
IP address
：
192.168.0.11
Subnet mask
：
255.255.255.0
Default gateway
：
192.168.0.1
5.2.3 Reset Key
The key on the development board is the reset key, which is used to manual reset GS11-EI.
5.2.4 LED
There are six indicators on the development board, and the description is as follows:
Index
Name
Description
0
Power
Power indicator, On: Power on;
Off: Power off
1
RTS
Reserve
2
TX
GS11-EI’UART transmits indicator;
Blinking: GS11-EI’UART is transmitting data;
Off: GS11-EI’UART isn't transmitting data.
3
RX
GS11-EI’UART receives indicator.
Blinking: GS11-EI’UART is receiving data;
Off: GS11-EI’UART isn't receiving data.
4
Run
GS11-EI status indicator,
On: In run status;
Off: In start-up status.
5
DataExch
GS11-EI data-interchange indicator,
On: In data-exchange status;
Off: Not in data-exchange status.
