28
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
Install
Installer
Instalar
Einbauen
Installare
取り付け
Instalar
Monteren
安装
5
6
Measure
Mesurer
Medir
Messen
Misurare
計測
Medir
Meten
测量
