SPX GSE tech-motive tool SD25 Series, User Manual

Page: 11 / 34

June 2004 T-40409-A Page 3
Think Safety First!
Working with fastening tools can be dangerous if safe and proper procedures are not followed. As
with all machinery, certain hazards can be involved with the operation of the product. Using these
tools with caution will considerably lessen the possibility of personal injury. If, however, safety
precautions are overlooked or ignored personal injury to the operator can result.
Always use common sense and exercise caution when using these tools. They can produce torque that,
unless properly compensated for, could cause personal injury. Remember, your personal safety is
your
responsibility.
Only GSE tech-motive tool- qualified service technicians should perform the procedures covered in
this manual. If you are an operator or service technician, you should become familiar with the
contents of this manual before operating, servicing, or performing maintenance on any part of the
fastening system, including the SD25 Series screwdrivers. Familiarization with all components of the
system can minimize the possibility that an accident or injury might occur.
SPX GSE tech-motive tool assumes no responsibility for personal injury or damage to equipment
resulting from misuse of these tools. After reviewing this manual you should also review all safety
procedures provided by your company and the equipment installer.
WARNING!
!
Failure to follow these rules can result in serious personal
injury.
General Machine Safety
•
FOR YOUR OWN SAFETY READ THE INSTRUCTION MANUAL THOROUGHLY
PRIOR TO OPERATING THE TOOL.
•
DO NOT WORK IN A DANGEROUS ENVIRONMENT. Do not use power tools in a
damp or wet location or explosive atmosphere, or expose them to rain, oils, or corrosive
fluids.
•
KNOW THE LOCATION OF POWER DISCONNECTS PRIOR TO OPERATING
THIS EQUIPMENT.
•
KEEP ALL ELECTRICAL PANELS CLOSED DURING OPERATION. High voltage
present inside enclosure panels can result in personal injury. Do NOT bypass or defeat
electrical safety devices. Turn the power actuator to the OFF position prior to any
servicing or maintenance of the controller.
•
OBSERVE ALL GOVERNMENT AND/OR COMPANY POWER LOCKOUT
STANDARDS.
•
NEVER OPERATE SOLENOID VALVES, LIMIT SWITCHES OR RELAYS
MANUALLY as this practice can create dangerous, unexpected machine movements.