Spirent DLS 400E3, Operating Manual

Page: 8 / 64

DLS 400E3 Operating Manual
Page 1-4 - Spirent Communications
7104000537 03/04 -2
Figure 1.3 Example Test System Setup
By using Spirent’s complete ETSI TS 101 388/TR-048 (.4mm gauge type)/ETR 328 solution to define and
deploy devices that meet performance and conformance standards, service providers will be able to offer the
next generation of services. For more information on compatible Spirent Communications products, see the
About Related Documentation and Products section of this chapter.
1.4 About this Manual
You should read Chapter 2 "GETTING STARTED" thoroughly before powering up the DLS 400E3 wireline
simulator. The remainder of this manual provides information about the various aspects of the wireline sim-
ulator, such as loop configurations, remote control, warranty, specifications and contact information.
We recommend you use our DLS 400E3 Software to configure and control the wireline simulator. However,
we detail common and device specific commands sets that can be sent to the wireline simulator’s control
module through the IEEE 488 or RS-232 interfaces, in Chapter 4 "COMMON COMMAND SET FOR
REMOTE CONTROL" and Chapter 6 "DEVICE SPECIFIC COMMANDS FOR REMOTE CONTROL".
If there are any questions after reading this manual, please contact your Spirent Communications sales rep-
resentative or a member of the Customer Service team. Please find contact information in Chapter 8 "CUS-
TOMER SUPPORT" of this manual.