60 Operations Manual
–
Wall Extruder (Frame Nailer Gen IV and Tables)
13
Trouble Shooting
Table 23, Trouble shooting
Trouble
Probable Causes
Correction
Guns not firing
Triggers not activating
Pneumatic trigger may be faulty
–
replace
if necessary
No air to gun
Check air supply to gun
Trigger jammed
Contact gun supplier
Plate sensor not activating
Check sensor clear and free of debris
and/or is being activated correctly.
Otherwise replace
Plate clamp sensor or Vertical
stud clamp sensor not
activating
Remove clamp cylinder cover and check
on condition of sensors, ensure that
sensor is being activated correctly.
Otherwise replace
Guns firing incorrectly
Each gun is supplied by
different air pressures
Clean air lines and ensure regulated
pressure to each gun is the same.
Damaged air lines
Check for bent or leaking air lines and
replace as required.
Guns incorrectly angled/have
mismatching angles
Adjust angle between nail guns as
required, and ensure they are locked into
position.
Guns not isolating correctly
when required
Check switches have turned correctly.
Check connection between switches and
guns, and replace lines as required.
Pins not activating
Pins jammed/broken
Check for obstructions. Repair/replace
parts/remove obstructions as required.
No air to cylinders
Check air supply to cylinders
Cylinders/attached
components jammed
Check for obstructions. Repair/replace
parts/remove obstructions as required
Pins activating incorrectly
Each cylinder is supplied by
different air pressures
Clean air lines and ensure regulated
pressure to each cylinder is the same.
Damaged air lines
Check for bent, broken, or leaking air
lines, and replace as required.
Damaged cylinders/attached
components
Repair/replace parts as required
Size selector switch
damaged/locking incorrectly
Check for obstructions. Repair/replace
parts/remove obstructions as required.
Pins misaligned
Re-align parts as necessary. Ensure other
assembly items are not interfering with
pin movement.
Pins obstructed
Remove obstructions as required
