20
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL
EN
Programmable Master
Programmable mode enables you to program the master transmit-
ter to transfer any or all individual channels when you activate the
trainer switch. This mode is ideal for beginners learning to control
individual channels while the master transmitter maintains control
of all other channels. The slave transmitter should be in Inhibit
mode, if available. The Master and Slave transmitters MUST
have the same programming.
Pilot Link Master
Pilot Link Master enables you to program the master transmitter
to transfer any or all individual channels when you activate the
trainer switch. Pilot Link Master is ideal for complex models,
as the master transmitter maintains control of all secondary
functions, such as flight modes, retracts, flaps and brakes.
Secondary functions can be individually assigned to the Slave
transmitter as necessary. It is not necessary to have model
programming in the slave transmitter.
Wireless Trainer Operation
1. Enter an unused model on the slave transmitter (computer
transmitter only).
2. Bind the master transmitter to the model.
3. Make sure the master and slave transmitter battery packs
are fully charged.
4. Make sure the slave transmitter is powered off.
5. Either in the Wireless Programmable Master setup page or the
Wireless Pilot Link Master setup page, select BIND. This will
put the master transmitter’s wireless trainer receiver into
bind mode. You should see the following screen:
Analog Switch Setup
6. Enter bind mode on the slave transmitter following the
instructions provided with that transmitter.
7. After a successful bind, the following screen should appear:
8. Move the trainer switch on the master transmitter to transfer
model control from the master to the slave.
9. Release the trainer switch and the master transmitter regains
control of the model.
Master Override
The Master Override feature enables the instructor to immediately
regain control of the model by moving the control sticks. After you
activate Master Override, the slave transmitter cannot control
the model until you reset the trainer switch.
To reset the trainer switch
1. Move the trainer switch to the OFF position.
2. Move the trainer switch to the ON position to activate
the slave transmitter.
Trainer Alerts
The Trainer Alerts menu allows you to select Voice, Tone or Inhibit for
the alerts given while training. You are also able to change the voice
alerts given to any selection from the pre-loaded list of voice alerts.
To change the trainer alert
1. Scroll to the alert you wish to change and press the scroll wheel.
2. Scroll to the alert you wish to use: Voice (default), Tone, or Inh.
3. Press the scroll wheel to save your selection.
To change a voice alert
1. Set the alert to Voice.
2. Scroll to the voice alert you wish to change and press the
scroll wheel.
3. Scroll through the provided list to the voice alert you wish to use.
4. Press the scroll wheel to save your selection.
Allows all sticks and pots to be used as a kick point to turn on functions like mixes.
To add a kick point:
1. Move the control stick, lever or knob to the desired kick point position.
2. Scroll to the desired kick point and press the scroll wheel once to save the selection.
To delete a kick point, scroll to the desired kick point and press the Clear button.
