Speidels Braumeister
Page 4 of 32
Ensure that you lay the mains cable such that it does not come into contact with sharp
objects. The cable must be fully unwound.
The Braumeister must only be used as intended. It must only be operated in a safe,
fault-free condition. Ensure to check the proper condition prior to each use.
Children, pets and frail persons:
For the safety of your children, keep packaging parts (cartons, polystyrene etc.) out of
children’s reach. Keep foils out of children’s reach.
Asphyxiation risk!
This device is not meant to be handled by persons (including children) with limited
physical, sensory or mental capabilities, or lack of experience and/or know-how,
unless they are being supervised by a person responsible for their safety or the person
has received instructions on how to use the device safely.
Children and pets must be supervised to ensure that they are kept away from the
device and do not play with the device.
2.2
Safety instructions
The temperature of the container, lid, and add-on parts can become extremely high.
Towards the end of the brewing process, the boiler contains boiling beer wort.
Observe the installation instructions. Never attempt to move the Braumeister while it
is hot. Always use pot holders or gloves when working on and with the Braumeister.
Risk of burning!
When lifting the lid, ensure that the condensation on the underside of the lid flows
back into the container. For this, hold the lid over the container at an angle.
Scalding
risk!
The Braumeister always operate via a residual current circuit breaker with a
tripping current of max. 100 mA type B (AC-DC sensitive).
A technical defect
carries the inherent
risk of electrical shock!
When performing cleaning activities on the Braumeister always ensure that the plug is
disconnected (disconnection from mains). . The terminals may still be live after the
equipment has been shut down. Wait at least 3 minutes. Do not spray the device down
or allow spray to come into contact with electric components.
Danger of electric
shock!
Important: It is imperative that you lock the plug connections at the rear of the device
(pump and heater) during the operation of the device. Operating the device without
securing plug and socket devices can lead to overheating.
Fire hazard!
Please use the thermal sleeve available as an accessory for insulation. When using
your own insulation ensure that the electronics and the lower part of the Braumeister
are sufficiently ventilated, as a heat build-up and damage to the control may otherwise
occur.
The pump must be vented prior to each use to prevent dry running. Venting takes
place routinely in automatic operation. In the manual operation, the pump must be
switched on and off several times until no more air bubbles escape.
In order to prevent any danger that may be caused by outdated components,
compliance with the maintenance and inspection instructions is mandatory.
