Spectrum Digital, Inc
3-10
DM368 EVM Technical Reference
3.2.7 J7, +5 Volts Input
Connector J7 is the input power connector. This connector brings in +5 volts to the
EVM. This is a 2.5mm. jack. The inside of the jack is tied to through a fuse to VCC_5V.
The other side is tied to ground and LED DS1. The figure below shows this connector
as viewed from the card edge.
3.2.8 J12, SD/MMC/MS Card Interface
The J12 SD/MMC/MS Card Interface connector is located on the top side of the board
and is used to provide an interface to a SD/MMC/MS card. The pinout for the J12
connector is shown in the table below.
Table 7: J12, SD/MMC/MS Connector
Pin #
Signal
Pin #
Signal
1
SD.DATA3
2
SD.CMD
3
SD.VSS1
4
SD.VDD/VCC_3V3
5
SD.CLK
6
SD.VSS2
7
SD.DATA0
8
SD.DATA1
9
SD.DATA2
10
GND
11
MS.BS
12
MS.DATA1
13
MS.SDIO/DATA0
14
MS.DATA2
15
MS.XINS
16
MS.DATA3
17
MS.CLK
18
MS.VCC/VCC_3V3
19
GND
20
WP
21
INS
22
GND
23
GND
PC Board
J7
+5V
Ground
Front View
Figure 3-6, J7, +5 Volt Input Connector
Summary of Contents for TMS320DM368
