Spectrum Digital, Inc
3-23
3.2.27 P2, Ethernet Interface
The P2 connector is located on the top side of the board and is used to provide an
Ethernet interface. P2 integrates the magnetics and standard RJ-45 connector. The
two tables below show the signals present on the magnetics interface and the
connector side.
The ethernet connector incorporates 2 LEDs which give link and transmit status from
the ethernet controller.
Table 26: P2, Magnetics/LEDs Interface Signals
Pin #
Signal
Pin #
Signal
1
TX+, U5, Pin 41
2
TX-, U5, Pin 40
3
RX+, U5, Pin 33
4
VDD_3V3A
5
VDD_3V3A
6
RX-, U5, Pin 32
7
NC
8
GND_E_NET
9
VCC_3V3A
10
EPHY_LED2
11
VCC_3V3A
12
EPHY_LED0
Table 27: P2, RJ-45 Connector
Pin #
Signal
Pin #
Signal
1
TXD+
2
TXD-
3
RXD+
4
TXD-CT
5
RXD-CT
6
RXD-
7
NC
8
GND
9
LED1+
10
LED1-
11
LED2+
12
LED2-
Summary of Contents for TMS320DM368
