57
Raw Data
Recording
On the receiver’s General Status screen, the following icons
will appear in succession at a rate of 1 second when the
receiver is actually collecting raw data:
Using the Web Server
Using the Web Server to launch data recording is particularly
suitable for remote-controlled, static raw data collection.
• Go to
Receiver
>
Memory
.
• Enable
Data Recording
.
• Enter a site name for the location occupied by the
receiver.
• Choose the memory where to save the raw data file.
• Choose a recording interval in Hz. Additionally, you may
ask the receiver to record the “TTT” message resulting
from the advent of any incoming external event and/or the
“PTT” message providing the time-tagging of the PPS
signal.
• Click
Configure
. The receiver starts recording the default
messages programmed on port M (as listed after
Data
type
). To change the content of this message, refer to
).
In the right part of the
Memory
tab screen, at the bottom
of the list of files stored in the selected memory, you can
now see – shown in red – the name of the file being
created.
Working from the Receiver Front Panel
Working from the receiver front panel to launch data
recording allows a rover operator to choose between “
Static
”
or “
Stop & Go
” data collection. A USB key connected to the
receiver front panel may be used to save the raw data file
once created.
• Press one of the horizontal keys until you see the “
Record
OFF
” screen.
1
GNSS Raw Data
Acquisition
