17
Special instructions for the ambiente a7/a8
It is possible to provide the stoves with a separate combustion air supply. The
separate combustion air connection is located at the rear of the stove (a7 only)
and on the underside of the stove (D = 100 mm). Proceed as follows to connect
up the combustion air supply.
Installation on underside of stove (a7 and a8):
Stand the stove on the floor above the combustion air connection. Now care-
fully lift off the stove covering. (
Fig. 8a
). Next, unscrew the screw cap. (
Fig.
8b
). Connect the combustion air connecting piece to the flexible, extensible
combustion air duct installed on site. If the combustion air connection is
rigid at floor level, the separate combustion air connecting piece supplied
must be pushed into the connection to form an airtight seal.
Installation at rear of stove (a7):
Start by unscrewing the screw cap (
Fig. 8d
). Now fit the combustion air
connecting piece (
Fig. 8e
). Lastly, connect the combustion air connecting
piece with the combustion air duct.
Fig. 8a
Fig. 8b
Fig. 8c
Fig. 8d
Fig. 8e
