13
2.3.3. FITTING THE STORAGE STONES
ambiente a3/a4
Storage stones can only be fitted or retrofitted to the ambiente a3 and a4
models.
If the ambiente a3 or a4 is ordered with storage stones, the front stone
and supporting plate are already fitted at the factory. For weight reasons,
the other storage stones are assembled on site. Stoves are supplied with
a rear flue gas connection as standard, unless otherwise specified at the
time of ordering.
To install the storage stones, start by removing the cover. Note that the
stove should not yet be connected to the chimney when doing this.
Fitting the front stone:
(only if retrofitting storage stones) Start by installing the front stone (A).
Next, fit the supporting plate (B) (
Fig. 6a
).
Fitting the storage stones:
ambiente a3 with top and side flue gas connection: Place the three shallow
stones in position to form a ring and replace the cover (
Fig. 6b
).
ambiente a4 with top flue gas
connection:
Start by placing the six tall stones
in position to form a ring. These
have a recessed handle on the
inside to facilitate assembly. Now
place the three shallow stones in
position to form a ring and replace
the cover (
Fig. 6c
).
ambiente a4 with side flue gas
connection:
Start by placing the two small
stones under the flue gas pipe,
and then place the four tall stones
in position. These have a recessed
handle on the inside to facilitate
assembly. Now place the two shal-
low stones in position and replace
the cover (
Fig. 6d
).
Fig. 6c
Fig. 6d
Fig. 6a
Fig. 6b
