Form 43343050
Jan 2014
-15-
10.0)
ASSEMBLY OF TUBE SECTIONS
Sheet metal parts, particularly reflectors and vent have sharp
edges. Always use gloves when handling.
Failure to do so may result in death, serious injury or property
damage.
CUT HAZARD
During field assembly of the heater body sections, the recommended procedure is as follows:
1.
Before hanging heater sections, first determine the actual layout of the system (see Sections 7.0) & 8.0) for
details). Consideration must also be taken for flue pipe, fresh air ducting, gas piping, clearances to
combustibles, etc. before hanging heater. Typical suspension methods are shown in Section 9.0).
2.
Hang each tube section individually. DO NOT
DO NOT
DO NOT
DO NOT attach the heater tube sections together on the ground and
attempt to hang the entire system.
3.
The first 10’ tube section must be aluminized steel (12-radial hole flange) as the primary heat exchanger
and the control box is connected directly to this tube section. Failure to attach the control box to the flange
Failure to attach the control box to the flange
Failure to attach the control box to the flange
Failure to attach the control box to the flange
end as indicated above will void the manufacturer’s warranty.
end as indicated above will void the manufacturer’s warranty.
end as indicated above will void the manufacturer’s warranty.
end as indicated above will void the manufacturer’s warranty.
4.
Place a tube support/hanger bracket on the end of the heat exchanger tube having the mounting flange.
Align the tube such that the welded seam is facing down toward the ground. F
F
F
Failure to assemble the tube
ailure to assemble the tube
ailure to assemble the tube
ailure to assemble the tube
with the seam facing down will void the manufacturer’s warranty
with the seam facing down will void the manufacturer’s warranty
with the seam facing down will void the manufacturer’s warranty
with the seam facing down will void the manufacturer’s warranty.
.
.
.
5.
Space the tube support/hanger bracket 6 inches from center of its slotted holes to the front face of the
mounting flange. Secure the tube to the support/hanger bracket using a “U” Bolt clamp and two (2) 5/16-18
nuts provided. For U-tube configuration, see typical assembly overview illustration in Section 8.2)
6.
Suspend the chain to attach the wire hanger and the tube support bracket. Insert the tube into the wire
hanger and then raise the tube support bracket end up to the suspension chain, use “S” hooks to attach the
wire hanger and tube support bracket to the chain.
Failure to assemble the tube with the seam facing down will void the
Failure to assemble the tube with the seam facing down will void the
Failure to assemble the tube with the seam facing down will void the
Failure to assemble the tube with the seam facing down will void the
manufacturer’s warranty.
manufacturer’s warranty.
manufacturer’s warranty.
manufacturer’s warranty.
END VIEW
4"OD x 10Ft. Heat
Treated Aluminized
Steel Tube
Control Box
Mounting Flange
(12 radial hole)
1
2
8 to 9 1/4
Maximum 6 distance from
control box mounting flange
to tube support bracket.
Tube Support/
Hanger Bracket
Wire Hanger
U-Bolt Clamp
& 5/16 Hex Nuts
S Hooks
Weld seam to the
bottom of tube.
