SP Scientific Freezemobile Series, Operator'S Manual, Page: 13 / 54

Rev 005, 02/12 3
© SP Scientific 2012
Chapter
2
Installation and Startup
Initial Inspection
Inspect the contents of your shipment immediately upon arrival. Check packing
material for possible small accessory items. DO NOT ACCEPT damaged shipments
from a carrier without a signed notification of damages.
If concealed damage and/or loss is discovered, contact the freight carrier immediately.
Keep the contents, packing material and related paperwork intact until the written
report is obtained.

If your shipment is “FOB Destination” file your claim with SP Scientific and
include the inspection report and any other supporting documents.

If your shipment is “FOB Shipping Point” file your claim with the freight carrier
and include the
inspection
report and any other supporting documents.
Note: SP Scientific will cooperate in the matter of collecting your claim, but is not responsible
for the collection or free replacement of the material. When possible, replacement parts will be
shipped and invoiced to you, making them a part of your claim.
Service Connections
Ensure that the outlet you intend to use meets the service requirements listed on the
serial tag of your unit. The serial tag is typically located on the front and rear of the
lyophilizer.
CAUTION! ONLY A QUALIFIED ELECTRICIAN SHOULD CONNECT THE UNIT TO THE AVAILABLE
ELECTRICAL SUPPLY.
SP Scientific ships Freezemobile units without a plug to locations where electrical
connections vary from standard U.S. requirements. The line cord has three individual
conductors inside the outer jacket.
To make the appropriate plug connection:
1. Trim back enough of the jacket to facilitate installation of the plug.
Serial Tag Example