Sourcetronic ST2826, Operation Manual

Page: 18 / 145

ST2826 Operation manual Ver1.0
◇
8
6) Assistance and data inputting zone
The zone is used to display the system notice and the input data.
2.4Main menu and corresponding displayed page
2.4.1 [LCRZ]
Start key about the capacitance, resistance, inductance and impedance
，
which includes
：
<LCRZ>
<Bin No.>
<Bin Count>
<List sweep>
<Test>
<Correction>
<Limit list>
<List sweep>
2.4.2 [SYSTEM]
For entering system setting page, about the start key of system setting and file list
function, the function pare includes
：
System setting
2.5Basic operation
The basic of ST2826 is listed as below
：

Use
（
[LCRZ],[SETUP],[SYSTEM]
）
and softkey to select the displayed page you need.
（
In figure 2-5
）

Use ([
←
][
↑
][
→
][
↓
]) to move cursor to the zone needs setting. When cursor is moved to
some zone, then it will display by inverse, the so-called zone means the zone where the
cursor can be set.

The function of softkey in the zone where there is cursor will be displayed in
―Softkey‖.Select and press the demanded softkey. Numeric key, [BACKSPACE] and
[ENTER] key is used to input data.
After pressing a numeric key
，
softkey zone will display the available unit softkey. You
can press unit softkey or [ENTER] to end data-inputting. When using [ENTER] to end
data-inputting
，
data unit is the default unit of the parameter in corresponding zone
：
Hz,
V or A. For example, the default unit of frequency is Hz.
2.6Open
Insert 3 line power plug
，
note
：
the feed voltage should be 198V
～
242V
，
the frequency should
be 47.5
～
52.5Hz. The phase line L, null line N, earth line E in power input should be the same
as that in power plug.
Turn on the power, and press the power switch at the left corner on the front panel
，
the