SA262
Ventris Dual Reverb Owner’s Manual
8
cable. It can also accept daisy-chained Neuro data from another Neuro-compatible pedal in the
chain, provided that a TRS cable is used. The audio signal (if applicable) will be on the tip contact
of the plug, and the Neuro App data will be on the ring contact. This allows audio and Neuro
data to flow on the same cable.
MIDI Input
This is a standard 5-pin DIN connector that accepts MIDI control messages from external devices,
including program change (PC) and continuous controller (CC) messages. Please email
regarding any questions about the Ventris Dual Reverb’s MIDI
implementation.
Output Side Connections
Output 1
This is the primary audio output. Connect it to your amplifier, recording interface, or the next device
in your effects signal chain using a mono (TS) ¼” cable.
Output 2
O
UTPUT
2 can act either as an audio output, external loop output, or as the daisy-chain data
connection for the Neuro App.
•
Output 2 as an Audio Output
:
The tip contact on O
UTPUT
2 acts as the secondary audio output. It
carries an audio signal when the Ventris is configured with a signal routing that uses stereo
outputs. Connect it to your amplifier, recording interface, or the next device in your effects
signal chain using a mono (TS) ¼” cable.
•
Output 2 as an External Loop Send:
If the Ventris is configured in a routing mode that includes an
external loop, O
UTPUT
2 is the loop send and I
NPUT
2 is the loop return. Connect O
UTPUT
2 to the
input of the external effects loop using a mono (TS) ¼” cable.
•
Output 2 as a Neuro App Data Daisy-Chain Output:
The ring contact on O
UTPUT
2 acts as a data
connection for the Neuro App, passing data from the Ventris to the next Source Audio effect in
your signal chain. You can daisy-chain the Neuro App data regardless of whether O
UTPUT
2 is