SA262
Ventris Dual Reverb Owner’s Manual
39
3.
Move the expression pedal over the range of motion you would like to use to control the
Ventris. If you would like to use the expression pe
dal’s full range of motion,
make sure to
move the pedal all the way from its minimum position to its maximum position. Note that
you can create “dead zones,” if desired, by only moving the expression pedal ove
r a limited
region of its full range of motion.
4.
After setting the expression pedal range, click the O
N
/O
FF
F
OOTSWITCH
once. The calibration
is now complete, and the C
ONTROL
L
ED
will blink faster (about 2 blinks per second). Now, it is
time to map the expression pedal to the effect parameters.
5.
Move the knobs and Neuro parameters (Neuro parameters only accessible when connected
to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the expression
pedal to the minimum desired position and then click the O
N
/O
FF
F
OOTSWITCH
. The C
ONTROL
L
ED
will now blink even faster (about 4 blinks per second). Note that you may control one or
more knobs with the expression pedal, up to six total knobs.
6.
Move the knobs and Neuro parameters you wish to control with the expression pedal to the
maximum desired position and then click the O
N
/O
FF
F
OOTSWITCH
. The C
ONTROL
L
ED
will now
be lit solid red.
7.
After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Note:
The parameter range can be inverted by swapping the minimum and maximum position of the
knobs during steps 5 and 6.
Note:
To cancel a control assignment, press the CONTROL INPUT button at any time during the
process above.
Note:
if you want to use the default Input Volume Control function but calibrate the range of an
expression pedal, do the procedure above but cancel the assignment after step 4 by pressing the
CONTROL INPUT button. The pedal calibration will be retained but no mapping to knobs will be
created.
Once a mapping is created, it can be stored as part of a user preset. This way, each preset can be
configured to have its own custom mapping.
External Control can be toggled on/off at any time by pressing the CONTROL INPUT button.
External Switch Used As Expression
Input (Expression “Toggle”)
An external switch can also work as a sort of expression pedal that only has two positions: on and off.
The external switch can be either momentary or latching.
External Switch as Expression Toggle (
1/4” TRS Connection –
PEDAL IN Jack)
To use this mode, connect an external switch to PEDAL IN and set the PEDAL IN switch to the EXP
position instead of the SWITCH position. The following plug configuration is required: