SA262
Ventris Dual Reverb Owner’s Manual
15
sync the tremolo to the music. Note: you must tap the switch a minimum of two times for the
pedal to change the tremolo rate.
OPTION FOOTSWITCH (PRESS & HOLD):
Reverb Hold
–
See the description in the ROOM engine
section.
S
HIMMER
(7)
This pitch shifting reverb engine mixes traditional room sounds with octave-up reflections for an
angelic reverb effect. Connect the Shimmer engine to the Neuro Desktop Editor and swap the
octave-up for variety of additional pitch intervals.
CONTROL 1:
Normal/Shimmer Crossfade
–
Controls the mix ratio between the normal reverb
effect and the pitch shifting reverb reflections. Turn the knob clockwise to gradually increase the
pitch shifting reverb and decrease the normal reverb in the wet mix.
CONTROL 2:
Shimmer Regeneration
–
Increases the amount of Shimmer signal that is fed back
into the reverb processor. To the listener, the Shimmer effect becomes more pronounced as this
knob is turned clockwise.
OPTION FOOTSWITCH (TAPPING):
Modulation Rate
–
See the description in the ROOM engine
section.
OPTION FOOTSWITCH (PRESS & HOLD):
Pitch Ramp Down
–
Functions similar to the HOLD
function except that as you press and hold the footswitch the Shimmer effect will slowly slip
downward in pitch. It can be quite a haunting effect. Note: with the Neuro Editor it is also
possible to send this pitch shift in an upward direction.
Expert Tip
: Try creating an A+B dual
Shimmer preset with the OPTION footswitch on Reverb A set to a Pitch Ramp Down and Reverb
B set to Pitch Ramp Up. Holding the OPTION footswitch yields a very interesting up/down pitch
event. See the
Neuro Sound Editor
for instructions on reassigning the function of the OPTION
Footswitch.
E
CHO
V
ERB
(8)
This ambient combination of delay and reverb provides a sprawling echo effect with huge,
reverberating repeats. The Echoverb engine can also act as a classic delay pedal by turning the
Delay/Reverb Crossfade knob to the full counter-clockwise position, thereby isolating the delay
effect. The Echoverb engine has a maximum delay time of 2 seconds.