722 User Guide and Technical Information
11
Left Panel Connectors and Controls
1
8
7
2
3
4
5
6
1)
XLR Input 1/AES3 Input 1&2
Dual function input connection. Input
type set with switch (
see #3
). Active-bal-
anced analog microphone- or line-level
input for input 1. Transformer-balanced
two-channel AES3 input (1 and 2).
2)
XLR Input 2
Same as Input 1 above for analog sig-
nals. Input type set with switch above.
Active-balanced analog microphone- or
line-level input for input 2.
3)
Mic-Line-AES3 Input Switch 1
Selects the input level and mode of the
input XLR 1 connector.
4)
Mic-Line Input Switch 2
Selects the input level, mic- or line-level
of input XLR 2. NOTE: there are two re-
dundant switch positions for line-level.
5)
TA3 Master (L/R) Analog Outputs
Active-balanced, line-level analog L/R
outputs for the Master Analog Out-
puts. Program source and attenuation
level are user selectable. Pin-1 ground,
pin-2 (+), pin-3 (
–
).
6)
Headphone Output
3.5 mm TRS stereo headphone connec-
tor. Can drive headphones from 8 to
1000 ohm impedances to required levels.
Tip left, ring right, sleeve ground.
7)
Headphone Volume
Adjusts the headphone volume. NOTE:
the 722 is capable of producing ear-dam-
aging levels in headphones.
8)
Tape Output
Unbalanced tape (–10 dBV nominal)
output on 3.5 mm TRS stereo connector.
Signal source is identical to the Master
Output Bus. Tip left, ring right, sleeve
ground.
