B - 5
B. Installation and setup
Imaging plate unit
9. Repeat the above process for all the other PCs in
the network. Make sure that you give each PC a
different
Workstation identifier
.
10. Check the installation by starting image capture
using the imaging software.
If the
Use Multi-Connect
was selected the
Workstation identifier of the PC (1 - 8) being used
will appear on the unit display.
IP method (using the unit IP address)
If your system does not allow the direct connection
method to be used to connect the PC(s), connection
can be done using an IP address
1. Follow steps 1 to 5 from the previous section,
Direct connection method (uses the unit s/n)
.
2.
PC:
From the the
Settings
tab select
IP based
and then select the
Enable changing IP
address
box.
